Blog Archives

POSTED

Nov30

138 DAYS

Slug Marks

Surface defects caused by scrap being indented into the metal surface.

READ MORE

POSTED

Nov30

138 DAYS

Slot-to-Form

Distance from a slot edge to the inside edge of a formed feature.

READ MORE

Advertisement

POSTED

Nov30

138 DAYS

Slot

A cut made in a fiberboard sheet, usually to form flaps and thus permit folding. Widths of one-fourth and three-eighths inch are common.

READ MORE

POSTED

Nov30

138 DAYS

Slitting

Cutting printed sheets or webs into two or more sections by means of cutting wheels on a press or folder.

READ MORE

POSTED

Nov30

138 DAYS

Slit Ddge

The relatively smooth edge produced from side trimming or slitting. See mill edge.

READ MORE

POSTED

Nov30

138 DAYS

Slit

A cut made in a sheet without removal of material.

READ MORE

POSTED

Nov30

138 DAYS

Slip Sheet

Paper sheet used between sections of a display or in between the display and the carton, in packing for shipping.

READ MORE

POSTED

Nov30

138 DAYS

Slip Compound

An ink or coating additive used to give lubricating or slip properties to the dried film.

READ MORE

POSTED

Nov30

138 DAYS

Slip Agent

Additive used to provide lubrication during and immediately following processing of plastics.

READ MORE

POSTED

Nov30

138 DAYS

Slide Hammer

A weight that slides along a rod with a head on one end and threads on the other end. Normally used to pull dowels and details. Commonly called a dowel …

READ MORE

POSTED

Nov30

138 DAYS

Slide Counterbalance Pressure (Counterbalance Pressure)

A device used on the slide of large and small presses to reduce vibration and to assist the brake and clutch in functioning properly. Counterbalances are actuated by springs or …

READ MORE

POSTED

Nov30

138 DAYS

Slide Counterbalance

A device used on the slide of large and small presses to reduce vibration and to assist the brake and clutch in functioning properly. Counterbalances are actuated by springs or …

READ MORE

POSTED

Nov30

138 DAYS

Slide Adjustment

The distance that a press slide position can be altered to change the shut height of the die space. The adjustment can be made by hand or by power mechanism.

READ MORE

POSTED

Nov30

138 DAYS

Slide

projection in the mold used to form the geometry of the part, which is not in direction of the closing of the mold and must be withdrawn before the part …

READ MORE

POSTED

Nov30

138 DAYS

Slatwall

Any paneling material (usually particle board) with specially fabricated linear slotting (usually T-shaped), that allows installation of appropriate brackets and hangers for use where maximum utilization and ease of reconfiguration …

READ MORE
...10...202122...304050...